WALKIE ONE - CAD FILES (ENCLOSURE)
Enclosure revision R38 - 29 October 2026 - for the Walkie One 06 board

Printable STL meshes, in millimetres. Print one of each per device.

  Front_shell_R38.stl                  front half of the case, 70 x 144 mm
  Rear_shell_R37_unchanged.stl         back half of the case, 70 x 144 mm
  Grille_flush_R37_unchanged.stl       speaker grille
  Speaker_retainer_R37_unchanged.stl   holds the 30 mm speaker
  PTT_cap_R38.stl                      Talk button cap (side)
  Play_cap_R38.stl                     Listen button cap (side)
  Volume_up_cap_R38.stl                Vol + button cap (side)
  Volume_down_cap_R38.stl              Vol - button cap (side)

Parts carrying "R37_unchanged" did not change in R38.

Status: prototype. Check the fit with your board before printing a batch.
The board, battery, speaker and antenna are described in the Build
instructions and Bill of materials downloads.

LICENCE
  LICENSE.md and NOTICE.md in this folder apply to these files.

More: https://walkieone.com/open
